| Problem | Cause | Solution |
|---|---|---|
| The Pentair Prowler 910 Pool Cleaner cable twisting or coiling up. | Obstruction in pool or excess cable. | – Remove any obstructions from the pool. – Install main drain cover ring if cleaner is getting stuck. – Straighten the cable and lay it in the sun to relax coils. – Remove excess cable from the pool. |
| The Pentair Prowler 910 Pool Cleaner moving around in circles. | Dirt in moving parts, worn tracks, incorrect power supply position, or algae in pool. | – Clean out dirt from moving parts. – Replace worn tracks. – Reposition the power supply for optimal coverage. – Treat pool for algae. |
| The Pentair Prowler 910 Pool Cleaner does not reach all areas of pool. | Incorrect power supply position, inability to climb walls, algae, or pool filter and pump running. | – Adjust the position of the power supply. – Check for issues preventing wall climbing. – Brush and clean walls to remove algae. – Turn off pool filter and pump during cleaning cycles. |
| The Pentair Prowler 910 Pool Cleaner motor not working. | Blocked impeller or drive system, electrical problems. | – Clear any blockage from the impeller. – Clean tracks and wheels to ensure movement. – For electrical issues, consult with a dealer or service center. |
| The Pentair Prowler 910 Pool Cleaner will not sink. | Air trapped in the cleaner. | – Turn the cleaner upside down underwater to release air. – Clean the cartridge and remove any deposits. – Open the inlet flap in the bottom lid to clear out debris and air. |
| The Pentair Prowler 910 Pool Cleaner power supply or supply switch light is not working. | Power supply not connected properly or damaged main socket. | – Ensure the power supply is properly connected. – Check the main socket for damage and repair or replace if necessary. |
Pentair Prowler 910 Troubleshooting
Most Common Pentair Prowler 910 Reported Problems
No categorized comments found for this post.Technical Malfunction Issues
No value found for field: technical_malfunctionsPower and Charging Issues
No value found for field: power_and_chargingPerformance Issues
No value found for field: performanceSetup and Usage Issues
No value found for field: setup_and_usageCustomer Support Issues
No value found for field: customer_supportOther Issues
No value found for field: otherPentair Prowler 910 Pool Cleaner Not Working?
If you're experiencing issues with your Pentair Prowler 910 pool equipment, you're not alone. Many users have faced similar challenges and have shared their experiences to help others troubleshoot and resolve these problems.
My right tire keeps kicking off I have put a new tread on the tracks. It this did not solve my problem
Submit Your Own IssueMy Pentair Prowler 910 control unit light only flashes on for a second when I push to button to start the unit. The unit will not turn on to start a cleaning cycle. Any thoughts?
Submit Your Own IssueTire tracks keeps coming off. I have replaced the tire. Is there an issue with the wheel itself
Submit Your Own IssueIt turns on and starts to move then just stops after about 30 seconds.
Submit Your Own IssueThe rear wheel broke off right, where it screws into the body. Is there a fix? The main body is not listed as a part.
Submit Your Own IssueWhen I turn it on it will run about 5 seconds one way and the 10 the other and shut off. I have only had this for a couple of months and am very frustrated that it quit working already.
Submit Your Own IssueI have the exact same problem – very frustrating
Submit Your Own IssueOur Prowler never goes up high up the walls and it does occasional wheelies in the water.
Submit Your Own IssueI’m having problems with the Prowler 910 not picking up the fine dirt particles from my pool. It was not a problem before, just recently and I have cleaned the 4 filters thoroughly.
Submit Your Own IssueMy Pentair Prowler 910 is not working AFTERZ I have cleaned out the impeller, the wheels and untangled the cord. When I put it back into the pool it will go forward about 3 feet and stop. I’ve called l three phone numbers in the owners manual and no one returns my call. The local pool center doesn’t have any other suggestions.
Submit Your Own IssuePlease advise.
Trips ground fault breaker from time to time. Have checked receptacles and drop cord
Submit Your Own IssueWill the power supply work if caught in rain?
Submit Your Own IssueThe Pentair Prowler 910 power supply is water-resistant but not completely waterproof. It is not recommended to leave it out in the rain without protection. It’s advisable to use a caddy for easier transportation and storage. If you are unable to bring the controller indoors, consider storing the robot under cover in a small plastic equipment shed or deck box to protect it from the elements. Taking these precautions can help prevent damage and prolong the lifespan of the controller.
Submit Your Own Issue