Water Tech Pool Blaster Max Troubleshooting
User Reported Water Tech Pool Blaster Max Problems
- Charging issues
- Rusty connectors
- Short battery life
- No suction
- Difficult power button
- Vacuum head stuck
- Battery not holding charge
- Water ingress in button
- Inconsistent charging light
- Motor runs but ineffective
Most Common Water Tech Pool Blaster Max Reported Problems
Technical Malfunction Issues
No value found for field: technical_malfunctionsPower and Charging Issues
No value found for field: power_and_chargingPerformance Issues
No value found for field: performanceSetup and Usage Issues
No value found for field: setup_and_usageCustomer Support Issues
No value found for field: customer_supportOther Issues
No value found for field: otherWater Tech Pool Blaster Max Pool Cleaner Not Working?
If you're experiencing issues with your Water Tech Pool Blaster Max pool equipment, you're not alone. Many users have faced similar challenges and have shared their experiences to help others troubleshoot and resolve these problems.
I had this problem too and you fix it by brushing the connections clean with a small wire brush.
Issue Category:
Other
Ownership Length:
N/A
Pool Blaster motor turns on but won’t vacuum. No suction.
Issue Category:
Performance
Ownership Length:
N/A
The charge I get now is very short lived. Maybe a minute if I’m lucky. Seems like that is a problem for many here. Any fix to this?
Submit Your Own IssueWon’t hold a charge- any tips?
Submit Your Own IssueMy device is no longer charging.
Submit Your Own IssueI wonder how to replace the V clips. I have a lot of trouble putting on and taking off pole because the buttons are so hard to push.
Submit Your Own IssueMine just fills up with water does not suck at all..
Submit Your Own IssueMine won’t charge and it has been kept inside the past two years. Charger shows green light only when plugged in.
Submit Your Own IssueThere are two little silver pins inside the charging hole where the red on/off switch is. The bottom one gets a bit rusty. Use a bristle brush and gently clean it. Also same happens on the charger square silver connector pins. Clean as well. Plug in and it will be green then it turns red to charge again. Also make sure the adapter power connection is good, it looks like the cable is wired in but it’s a connector as well. Good luck.
Submit Your Own IssueSuggest using a small wire brush to clean the usual slight rusty or discolored connectors on the Blaster. They are inside the charging area above and below the red switch. Then the charger comes on green but will turn red to show charging again.
Submit Your Own IssueWhen I plug the pool blaster max hd lot into the charger it is a constant green light yet the machine is not charged at all.
Submit Your Own IssueIt won’t charge. Just Barely. I paid over 300 dollars for this and it doesn’t work was only used a couple months.
Submit Your Own IssueWhen taking it out of the pool while running, the residue dirt goes back into the pool, Why?
Submit Your Own IssuePool Blaster will not charge and button when pushed doesn’t turn the unit on
Submit Your Own IssueMine was the off and on button coming apart and getting water in it. Once it dried out, it worked. But I noticed it because while using it I saw bubbles coming out of the rubber button. I’m going to try a liquid rubber stuff. We’ll see
Submit Your Own IssueMy max will not charge or turn on. Worked fine last year and stored inside for winter. I’ve tried 3 different chargers and still nothing. It was new last year. What am I missing
Submit Your Own IssueThis is the problem I’m having. It worked all last year, when it was new. Now it’s DEAD. Were you able to solve your problem?
Submit Your Own IssueThe device is unable to rotate to the position labeled “On” and stops at the “Off” position.
Submit Your Own IssueMy Pool Blaster Max Li CG won’t change. The light just stays green and won’t turn red in charge mode when connected.
Submit Your Own IssueI have the same problem. Did you fix it?
Submit Your Own IssueMine too! How did you fix it?
Submit Your Own IssueMy PB Max Li worked for a couple years. Same…green light not charging. 12.8 v measured on charger with battery connected. 0.0 v on battery when not connected to charger. Battery appears to be open circuited, like an internal safety fuse blown (maybe), which is better than a fire. Battery also spec’d at 11.1 v instead of 8.4 v as seen on non-OEM batteries being sold for this product.
Submit Your Own Issuesame problem, won’t charge. Still looking for a solution
Submit Your Own IssuePool blaster max . Motor runs but there is no suction.i have done all the tips such as reversing the filter and fold it down as well as rubber banding the end of filter. Is there a way to replace the impeller? Any other ideas why this would happen?
Submit Your Own Issuethe power button will not turn the vacuum on
Submit Your Own IssueI cannot get the vacuum head to come off. Therefore, I cannot clean out the filter bag.
Submit Your Own Issue