| Problem | Cause | Solution |
|---|---|---|
| The Pentair Rebel cleaner is not moving or is moving too slowly. | Low flow, debris in cleaner, pump not primed, leaks, clogged system, insufficient pump/filter system. | – Check flow with flow gauge or calculate cleaner RPM and adjust using the regulator valve. – Inspect for and remove debris inside the cleaner. – Ensure the pump is primed and check for leaks. – The filter may need backwashing. – Ensure only the suction line to the cleaner is open. – Check for obstructions in filter, pump basket, or impeller. – Consult a pool professional if pump/filter system may be inadequate. |
| The Pentair Rebel cleaner’s right wheel will not turn when rotated by hand. | Obstructions inside the cleaner. | – Inspect for and remove obstructions inside the cleaner. |
| The Pentair Rebel cleaner stays in one end of the pool. | Low flow, incorrect return line water flow, short hose, incorrect hose float placement, dirty swivel assembly. | – Check flow with flow gauge or calculate cleaner RPM and adjust with regulator valve. – Redirect return line water flow with eyeball diverter. – Ensure hose is long enough. – Adjust hose float placement. – Clean swivel assembly if it does not rotate smoothly. |
| The Pentair Rebel cleaner climbs the wall too much or climbs out of pool. | High flow. | – Check flow with flow gauge or calculate cleaner RPM and adjust with regulator valve. |
| The Pentair Rebel cleaner won’t climb the pool walls. | Worn tires, low flow, incorrect leader hose installation, incorrect hose float placement. | – Check and replace tires if excessively worn. – Check flow with flow gauge or calculate cleaner RPM and adjust with regulator valve. – Ensure leader hose is installed correctly. – Adjust hose float placement. |
| The Pentair Rebel cleaner stays on the main drain. | Main drain not closed, missing main drain grate. | – Ensure the main drain is closed or consult a pool professional. – Check that a main drain grate is properly installed. |
| The Pentair Rebel cleaner falls on its side and takes too long to recover. | Incorrect hose float placement, incorrect leader hose installation, short hose, return eyeball fittings misdirecting cleaner. | – Adjust hose float placement. – Ensure leader hose is installed correctly and located properly. – Check hose length and ensure it reaches the furthest point. – Adjust return eyeball fittings if they are pushing the cleaner hoses away. |
Pentair Rebel Troubleshooting
Most Common Pentair Rebel Reported Problems
No categorized comments found for this post.Technical Malfunction Issues
No value found for field: technical_malfunctionsPower and Charging Issues
No value found for field: power_and_chargingPerformance Issues
No value found for field: performanceSetup and Usage Issues
No value found for field: setup_and_usageCustomer Support Issues
No value found for field: customer_supportOther Issues
No value found for field: otherPentair Rebel Pool Cleaner Not Working?
If you're experiencing issues with your Pentair Rebel pool equipment, you're not alone. Many users have faced similar challenges and have shared their experiences to help others troubleshoot and resolve these problems.
Rebel won’t sink all the way to the bottom after expelling all air
Submit Your Own Issue