- Power and Connectivity Issues:
- Ensure that the power supply is properly connected to the control unit.
- Check if the power outlet is functioning correctly.
- Inspect the power cord for any visible damage or cuts.
- Reset the control unit by turning it off and on again.
- Verify that the cable connections between the control unit and the cleaner are secure.
- Lack of Movement or Limited Coverage:
- Clean the filter bag or canister to remove debris and ensure optimal suction.
- Verify that the drive belts are intact and properly aligned.
- Check the brush assembly for any tangled debris or obstructions.
- Inspect the impeller for clogs or damage and clean or replace if necessary.
- Ensure that the cleaner’s wheels are clean and free from debris, allowing smooth movement.
- Floating or Submerging Issues:
- Check the buoyancy of the cleaner. Adjust the float settings if necessary to achieve the proper balance for floating or submerging.
- Clean the drive tracks or wheels to ensure they are free from debris that may affect buoyancy.
- Verify that the impeller is clean and functioning properly, as a clogged impeller can affect the cleaner’s balance.
- Filter Bag or Canister Clogging:
- Empty and clean the filter bag or canister regularly to prevent excessive debris accumulation.
- Rinse the filter bag or canister with water to remove any trapped particles.
- Inspect the filter bag or canister for any tears or damage. Replace if necessary.
- Power or Motor Issues:
- Check the power supply to ensure it meets the required voltage for the Aquabot Turbo T2.
- Inspect the motor for any signs of overheating, unusual noise, or burnt smells. If detected, contact the manufacturer for further assistance.
- Ensure that the cleaner’s drive belts are properly aligned and not slipping. Adjust or replace them as needed.
- Remote Control Problems:
- Verify that the batteries in the remote control are fresh and properly installed.
- Check for any obstructions or interference between the remote control and the control unit.
- Ensure a clear line of sight between the remote control and the control unit.
Aquabot Turbo T2 Troubleshooting
Most Common Aquabot Turbo T2 Reported Problems
No categorized comments found for this post.Technical Malfunction Issues
No value found for field: technical_malfunctionsPower and Charging Issues
No value found for field: power_and_chargingPerformance Issues
No value found for field: performanceSetup and Usage Issues
No value found for field: setup_and_usageCustomer Support Issues
No value found for field: customer_supportOther Issues
No value found for field: otherAquabot Turbo T2 Pool Cleaner Not Working?
If you're experiencing issues with your Aquabot Turbo T2 pool equipment, you're not alone. Many users have faced similar challenges and have shared their experiences to help others troubleshoot and resolve these problems.
the controller’s 2.5A fuse blows, when i press c run
Submit Your Own Issue