Aqua Products Dash Troubleshooting

The Aqua Products Dash robot moving too slowly/
not sucking debris

Corrective action

• Clean the filter bags.
• Check to ensure the suction ports are not clogged or blocked.

All the Aqua Products Dash LEDs are flashing on the power supply

Corrective action

• Check if cleaner is turned on when out of the water
• Check the motor protection screen, filter bag may be stuck.
• Check the propeller.
• Restart the cleaner. Press On/Off button, cleaner will resume.

The Aqua Products Dash floating cable is coiled or tangled

Corrective action

• Lay the cable flat in the sun on the ground to straighten.
• Change the order of the wheel axle pins.
• Verify the floating cable enters the water near the middle of the pool
  length. (TIP: mark the correct length with black electrical tape)
• Reduce the amount of cable in the water

The Aqua Products Dash cleaner not sucking debris

Corrective action

• Check cleaner is set up properly and turned on.
• Make sure the filter bags are clean.
• Check the propeller.
• Adjust the suction ports under the cleaner for blockages.

The Aqua Products Dash cleaner is stuck in the middle of the pool and is pumping out water

Corrective action

• Check for obstructions or any loose objects in the pool.
• Check and adjust the height of the suction ports. They may be
  touching the bottom of the pool.

The Aqua Products Dash pattern stays in a certain area of the pool

Corrective action

• Restart the cleaner at a different end of the pool.
• Check for correct pool size setting: Large or Small.
• Change the order of the wheel axle pins.

The Aqua Products Dash cleaner does not cover entire pool

Corrective action

• Clean the filter bags.
• Adjust the cycle time setting.
• Check the wheels and axles for blockages.
• Change the order of the wheel axle pins.